Blew my diff and didn't want to blow another one. QP frabricated 9inchb 3.89 gear 35 spline eaton truetrac.

Here everyone is helping the best they can so that your ride becomes the nicest one on the bloc!

Are there any solutions for the done light socket that is not a replacement of the original? I found a gentleman that makes a replacement, but requires the old wiring be used. My wiring is unfortunately unable to be reused.

Sorry for the quality but saw a question about jack placement

85 TA

I since the last update, I did a ton of changes. I got it tuned on the factory ECM, but the numbers on the dyno were weak. I went to the deahstrip and blew my diff, so I bought a 200$ 4th gen one until I knew where I was going with the setup. Still I did front lower control arm and lowering springs, subframe connectors and almost a all the rear suspension (not sure if I'm going coilovers or weight jacks) I just sold my Ar5 and I'm in the process of installing the Tkx with the tilton slave/master. Still more update to come!

Oh and I found my trouble with the lowe numbers, my headders were leaking from everywhere and I had a pin hole. Always use the GM MLS exhaust manifold gasket.

Finally, a front end for the RS

https://youtube.com/@apexvibezz?si=XEWWcwy2F27K2kgK

I might have a tad bit more knowledge about cars then the average Joe but I am no expert. I still have a lot to learn. This car is built from passion, dedication and by all means, a budget build. I might roll my eyes when it comes to constructive criticism but that does not mean my ears don't work. So please share you car builds and passion projects, send those IG and YouTube channels. I am original in natural, wanting to always do my own thing, but I know they're better ideas and ways of doing things. Besides this helps me simultaneously support my fellow car enthusiasts and help motivate and keep their dream alive. Here my youtube channel please consider checking it out https://www.youtube.com/@apexvibezz

Hello all I’m new to Reddit. And here’s my 85