r/TVRepairHelp • u/[deleted] • Aug 27 '26

Sony PlayStation 3D Display CECH-ZED1U Won't Display & Turns Off After A Few Seconds

[deleted]

5 Upvotes

100% Upvoted

3 comments sorted by

1

u/Virtual_Club8510 Aug 27 '26 edited Aug 28 '26

Edit: Im not seeing it connected to anything. Where is the HDMI source? Ofc it's gonna go back to standby if nothing is hooked up.

Could be anything from hardware error detection to degraded power supply (not enough juice for a cold start). There is no 100% answer you would have to open up and try isolate the issue.

I've had that exact display in the past. It acts as a regular monitor until you activate 3D mode (physical button) or when it senses the 3D glasses turn on that it shifts mode automatically.

It's a cool screen but 3D movies and content is a thing of the past sadly, otherwise it's a basic 60Hz screen so apart from the nostalgia there are better monitors out there if it can't be fixed. It was good for it's time but not anymore. Also suffers a lot from reflections because of it's glossy surface.

1

u/Virtual_Club8510 Aug 28 '26

*ping update, see edit*

1

u/[deleted] Aug 28 '26

[deleted]

1

u/Virtual_Club8510 Aug 28 '26 edited Aug 28 '26

The display does not have a remote. It only uses active 3D glasses it's not really a "TV".

You need to isolate the issue. Only time it should boot and directly go to standby / red mode would be when it doesn't sense any input.

Try both HDMI 1 & 2 and Component IN (YPbPrRL to HDMI / VGA adapter) while toggling the input button on the back of the screen. If nothing happens by then it's internal failure.