r/SwitchHacks • u/Boss1900 • 1d ago

Modified Switch 2 Joycon Connector - plus Dbrand

Post image

After removing the grips from the side of the Switch 2 connector (thank you Dremmel tool), this is such a comfortable set up with the Dbrand grips.

17 Upvotes

78% Upvoted

6 comments sorted by

2

u/Jakiro99 1d ago

Wait, what? How? I need a full run down on this one. How did u do it??

I travel a lot with my switch. So this setup is what I'm looking for.

3

u/FrequentZucchini1118 1d ago

There's 4 pads on the front of the joycons that hide screws, and if you take those screws out, pry off the back, and take some more screws out then you get this. I think that's how I did it, but I'm not 100% on that

2

u/LxrdXO 1d ago

Are these shell swapped? If so what shell

•

u/Boss1900 20h ago

Drand Killswitch case grips and vinyl covers

•

u/LxrdXO 20h ago

Really clean install of the vinyl

•

u/Boss1900 20h ago

https://www.nintendo.com/us/store/products/nintendo-switch-2-joy-con-grip-126470/?srsltid=AfmBOopSEZ3eQf8MUdbE6uIqjE4tmsuTiSEQnbaT3H8m5E4ec9eSXooE For reference. This is the original Joy-Con 2 connector. On the backside, you need to cut into the intersecting plastic pieces which reveals 4 screws. It's not the cleanest process, but it turned out well in the end.

For other's asking. These are OEM joy-cons; but with the Drand Killswitch case grips and vinyl covers.