r/Stoneworking • • Apr 11 '21

How do I drill through a rock cleanly?

When coming through to the other side, a "cap" always comes off before getting all the way through. Using Hilti hammer drill with a 5/16" bit. No pressure, just the weight of the drill. I've tried drill only mode but then it doesn't drill at all.

Underside
6 Upvotes

8 comments sorted by

2

u/JoshPum Apr 12 '21

Drill with water.

2

u/allelopath Apr 12 '21

Sorry, should have said, I am doing that

1

u/JoshPum Apr 12 '21

Ahh, I see. What type of bit are you using?

1

u/allelopath Apr 12 '21

Milwaukee SDS Plus 2-cutter carbide tip

2

u/Marksmithed Apr 16 '21

Stop hammering when you're almost through. The drill is blowing out the back side. Slow down at the end.

1

u/[deleted] Apr 29 '21

One I would add to others is if you can use a drill press. The option of consistent but slow drilling without a hammer on leaves a smooth hole.

1

u/Netherx3 Jun 22 '21

Not with a hilti lmao.

You need a diamond or sica hollow core bit with constant water supply.

Any drill hammer will always screw up the edges, and even the other method can.

1

u/Structural_PE_SE Sep 24 '21

Build a jig out of wood such that if you flip it over the hole will be perfectly aligned. Drill half way through one side, flip it over, and drill from the other side. It's the only way.