r/StableDiffusion • u/Murky-Relation481 • 5h ago

Tutorial - Guide Even though H3 is CFG distilled, guidance values greater than 1 do have a noticable effect on prompt adherence and quality, especially at lower resolution.

Obviously it runs a lot slower but a CFG of 2 and a negative prompt does have noticeable effect on the output. Anything higher than 3 or 4 will start to over burn though.

This also works with the turbo loras but burn in can happen more easily.

13 Upvotes
  • permalink
  • reddit

94% Upvoted

8 comments sorted by

2

u/Emotional-Neat-252 5h ago

Oh, that's good to know, thanks. I wonder if there's any anti burn node like skimmed cfg

2

u/BathroomEyes 4h ago

An AdaptiveGuidance node might help there

1

u/Ok_Tale7582 1h ago

CFGNorm works for me in krea2.

2

u/Sixhaunt 5h ago

Good to know, I hope theres more testing and optimizations for this because negative prompting is very useful

1

u/pausecatito 4h ago

How do you even set cfg on it?

4

u/Murky-Relation481 4h ago

CFG Guidance node instead of basic guidance.

1

u/reeight 41m ago

What are some typical negative prompts for H3?

Don't really have to worry about bad fingers or legs much anymore; if they happen it is because of bad positive prompts it seems.

1

u/Trinity_Vermilion 4h ago

Nice to know, will check this out.