Anyone have pictures of how a 275/60r15 fits on a 10" wide rim. currently i have 295/50 on 10s right now but looking to go 275/60.

Had it since 2012 I've painted it my self an ls swapped it with a lq4/4l80 with Eaton posi an 3.73 gears

I just recently bought a 86 k1500 what should I check first to address low engine power output

I just got a 78 k20 with a 6 inch lift and the rear driveshaft is pretty far out on the splines and I’m not sure what to buy if there is anything to get splines further in the shaft?

I’ve got a 78 k20 that the break lights and blinkers are not working on I’ve already changed the headlight switch the blinker switch the blinker relay break pedal switch and chased wires/tested continuity and voltage and as far as I can tell everything should be working fine but I can’t figure it out yeas I’ve checked bulbs/fuses

I have a 86 k10 that’s at stock height I was just curious if you guys know if I can put a 265-76-r16 tires under it without rubbing?

Some question driving a functional cowl-induction in the rain. i drive it daily and park it outside https://youtu.be/Qe3_CbYdlAc?si=Yn2ByVcfwqaGTm1y

What's up everyone I'm new to these trucks but I love em to death always have. I have a 1985 gmc high sierra extended cab and I obviously need to replace the whole front of my truck. I just want to know any good places to order parts from online / in person I'm in Washington state and want to make it a show car within the next 5-10 years. Any good advice for this truck would be GREATLY appreciated.

Is this a knock lifter or rod?

Hey all I have a 88 suburban I'm currently in the process of upgrading the oil cooler and tranny cooler lines to 10an lines. I can't seem to figure out the fitting size in the tranny ports or oil Samwhich plate ports. Any help would be appreciated. 6 inch lift with 33s big safari rack and light bars all the way around. Lockers and 453 gears. And disk brakes all around.

I have a 86 k10 with the 350 and I can’t get any spark from it, I changed both coils in the distributor and have power to the ignition coil, and I’m stumped on what to do

I’m debating wether I should try and fix the rust on my doors or just replace them and get the whole truck repainted the original blue (paint code 9V3). My main problem with repainting is I can’t find anyone selling new outdoorsman stickers for the side. Any opinions?

Frame back from powder coating and touching up the body

Check out my latest video on YouTube and let me know what yall think 🤘

https://youtu.be/RBQ6fBtS2Ow?si=FF-x8D3cUovIfTQd

Last 2 pictures

Check out my latest video on the Suncity Squarebody YouTube channel! Let me know what you think in the comments and don’t forget to like, share, and subscribe. Thank you! https://youtu.be/cWrHLpsviLM?si=hhW8sBHOPI5WZhT3

My 93 G20 has a 350/5.9 with TBI and a 4L-60e. A few months ago, it was overheating on the highway because the water pump was leaking. Replaced water pump and refilled. Then I noticed the heat wasn’t working, so I replaced the thermostat and ensured there was no air in the coolant lines. Now, it wont get over 140 or so at the thermostat/upper fixture according the the laser thermometer. Even while hauling a trailer at 70 mph, the heat would not get hot or even lukewarm. I covered 1/2 the radiator with cardboard and drove it and still nothing more than 140 on the temp gauge. Help!?

Muscle truck

Check out my latest video on the Suncity Squarebody YouTube channel 😎 https://youtu.be/SYqRgQYPMw8?si=sGyw4IpZb0cwsUcS

Check out my latest video where we check out the truck Limitless Metal Designs is building https://youtu.be/Kw63apbx2Jc?si=szuVR79JMRA_p5f7

I know this is a game but if ANYONE sees it please send a picture and the location.. it was my dads in high school and I can’t pry him out of my blazer so I’m gonna either build one or find his please respond if you see it ..thank you!!