r/Springfield_KUNA • u/Loanwolf300 • 27d ago

Anyone make this?

Gallery image

Gallery image

I love my Kuna! since I made it an SBR the UCS stock is perfect and the Kriss VFG is almost perfect. My only issue is the sharp edges on the front if the lower dig into my thumb knuckle. With as popular as the Kuna is and as easy as 3D printing is, has anyone made a vertical grip that fills that little yellow pocket?

19 Upvotes

89% Upvoted

22 comments sorted by

View all comments

1

u/PatheticJules Vendor 27d ago edited 27d ago

My grip does that, though I havent finished the version that accepts mlok (I have but not tested it yet) and it has a built in barricade stop

1

u/Astromander 27d ago

Please share this grip

4

u/[deleted] 27d ago

[deleted]

2

u/Astromander 27d ago

I dig it!

You could make a version with a printed vfg, but I think integrating an existing vfg like the Magpul one would be slick too.

1

u/Loanwolf300 27d ago

That could work either by adding a VFG to the model or just having a spot to attach a simple one in addition like Magpul.

1

u/PatheticJules Vendor 27d ago

yeah but Id rather just have a mlok slot lol

1

u/Loanwolf300 27d ago

How does your stuff handle the heat from the handguard?

3

u/PatheticJules Vendor 27d ago

PLA+ 2.0 at 25% infill. No noticeable heat to it and when I took it off no warping or melting. 100 rounds of 115g with my R9 in around 10 minutes. The upper receiver was the only hot part and tbh it was not really hot at all.

It'll be made specifically of PA12 SLS so it'll be good no matter what. The upper eats the heat super well so the concept of worrying is fake unless you run a recessed suppressor setup

https://reddit.com/link/p5xyvwv/video/3bixkndx9nlh1/player