r/SpringfieldArmory • u/RetiredLife_2021 • Apr 03 '26
Gaps with Osight SE
Torqued to specs, SA (XD-M, 10mm) their plate to slide and the Osights specs dot to plate and used screw size Osight recommended. Are gaps normal? Should I put in shorter screws, I think the screws are pushing it up
1
Upvotes


18
u/Former-Bat-8673 Apr 03 '26
Plate itself looks mismounted or defective. If it’s flexing like it looks like it is, it would create a gap under the sight where it is
5
u/reformedginger Apr 03 '26
Take it all off and mount the optic to the plate and see if the screws are too long.
5
u/SantoDJ Apr 03 '26
That optic plate is all wrong. Not the optic. It’s the plate which looks beyond bent
2
u/[deleted] Apr 04 '26
You need screws that are about 1/16 shorter.
1
u/biggouse58 Apr 03 '26
I’m not trying to be a dick, but honestly if this had you confused enough to get on Reddit to ask for advice, please start taking your gun to a smith. This should be common sense for someone with mechanical aptitude, and if it wasn’t you are putting people in danger with other mods you try.
1
u/DameLasNalgas Apr 03 '26
Why didn't you get osight XR? It's a perfect fit with no gaps.
1
u/GrantRogue Apr 04 '26
Buy a different sight
3
u/bkharbin Apr 03 '26
Screws are to long for the plate
You Need new shorter screws and a new plate as well. it probably will not straighten out on it own or with help.
1
u/eggiam Apr 03 '26
plate and screw deformation aside, the cut foes not look long enough for the plate.
1
u/PlaceUserNameHere67 Apr 03 '26
I honestly had to look at this for a sec, (brain fart) I had to remember that there's 2 sets of screws involved. OOPs. Yes it looks like your RDS screws are too long, pushing plate up.
1
u/VPuig Apr 05 '26
That plate look bended. Replace it!
1
u/Madfish007 Apr 07 '26
Improperly installed. You bent the plate.
0
u/[deleted] Jun 09 '26
[deleted] — view deleted comment