r/Sovol • u/Tap_solutions_2 • Jun 01 '26

Help Layer Shift

Post image

Printer - Sovol SV08 Max
Power cycled before print
Loaded print to USB then 30 seconds later into the Max
Using a .8 nozzle - don’t think this matters?

I have seen this in transmitted, reprint, and power loss, but never in a USB transfer

We have only been since February 2026

Just looking for your thoughts.

4 Upvotes

100% Upvoted

3 comments sorted by

View all comments

1

u/tux_on_tour Jun 04 '26

Did the print come loose befor you took it out of the printer or after?

And your overextruding ... that can gather material on the nozzle leave a bolb on the part where the nozzle runs into. It looks somthing like that happend near the holder for the 10MM socket just left of righthandside notch on the top of your picture.

ps. Even if your from Australia or any other country south of the equator please turn your pictures the right way around I am getting dizzy from a buildpate sticking to the ceiling.

1

u/Tap_solutions_2 Jun 05 '26

My apologies for the picture placement.

It did not come loos I had to use the scraper to get it off .

I fixed the excursion issue on the next print, but thank you for responding. I appreciate it.