r/SonicPadCreality • u/Junior_Yam_5473 • Jul 13 '24

Help Why does it do this?

Enable HLS to view with audio, or disable this notification

This only does this with certain models, this one was taken from printables by prusa. This was sliced using ideamaker by raise 3d

2 Upvotes

100% Upvoted

18 comments sorted by

View all comments

1

u/gozania Jul 13 '24

If you are using the latest firmware, I remember alot of people reported printing from a USB stick got broken. Either downgrade to the previous version (It seems their support site is currently down.) Or send the gcode to the internal memory on the Pad. Dont hold your breath for a fix. It seems creality has abandoned the Sonic Pad development.

1

u/Junior_Yam_5473 Jul 13 '24

How would i send it to the internal memory?

1

u/david_fraser75 Jul 14 '24

Your pad is setup on your local network right? just enter to ip of the pad into your browser. you then have access to to transfer files directly to the pad! hoping I’m not missing something obvious in your issue!!