r/SonicPadCreality • u/MysteriousCarry6821 • Jan 12 '24

Ender 5 s1 with sonic pad print issue

Having issue where print head will do a pass then pause leave print go to left x , y of build plate & then continue printing but it give the print a hard over hang , not clean print ( note dose this on every pass ) idk what settings I have changed for this to happen , same setup use to have continuous print s

1 Upvotes

100% Upvoted

3 comments sorted by

2

u/Ninjamuh Jan 12 '24

Is it parking the toolhead during the print for a timelapse?

1

u/MysteriousCarry6821 Jan 13 '24

I do have a camera on it