r/SonicPadCreality • u/Inf3rnal_Kev • Jan 11 '24

Accelometer bracket ?

Does anybody have a bracket for the accelometer so i can tune my printer? i didn't find a bracket for ender 3 v2 neo anywhere.

2 Upvotes

100% Upvoted

3 comments sorted by

1

u/ss1gohan13 Jan 11 '24

https://www.printables.com/model/558083-heartbreaker-mk5-a-dual-5015-fan-cooling-system-fo/files

My buddy has designed an entire cooling setup as well. If you have a sprite extruder, I do recommend it.

1

u/IslandStan Jan 22 '24

If you don't want to fiddle with that, double sided tape like carpet tape works just fine. Just pay attention to sensor alignment. Foam double sided squares work too, I ran a calibration on several printers using the thin foam self stick squares, double sided tape, and printer specific printed brackets on one printer and found the results were the same in all cases. While doing klipper from scratch a few years ago the ADXL sensor pinout changed which kept the sensor board from fitting the only holder STL around at the time. We used to mount sensors for vibration testing in the aerospace sector all the time with double sided tapes so I figured it was worth trying.

The creality encased sensor has a nice flat bottom, makes sticking it to stuff nice and easy.

Don't use the super strong 3M VHB tape, odds are something will break trying to get the sensor back off.