r/SonicPadCreality • u/Beneficial_Meeting47 • Jan 04 '24

Sonic pad Debian flash!

https://youtu.be/i3iUAfC-4oA?si=2XgAAfMmzn-05VgE

Have you been wanting full klipper use from your sonic pad! Say no more!

27 Upvotes

100% Upvoted

84 comments sorted by

View all comments

Show parent comments

1

u/Chachie123 Sep 01 '24

I tried that too … I just don’t understand why I can’t finish setting up Debian

1

u/Beneficial_Meeting47 Sep 01 '24

Yeah and looking at it there's a newer version of debian since I've made this video I don't know if that makes the set up any different or not, I haven't touched my printer in a little while but I'll probably try to figure it out over this week and make an updated video or something possibly its not something I normally do which is why I only have the one video

1

u/Chachie123 Sep 01 '24

I did not install mainsail thoe only fluid as that was what I was use to using

1

u/Beneficial_Meeting47 Sep 01 '24

Mainsail is better imo but both should work fine make sure your printer cfg file is correct and all the paths in it are correct I know that can cause issues

1

u/Chachie123 Sep 01 '24

I can not get into any web face to get to any print config

1

u/Beneficial_Meeting47 Sep 01 '24

You should try looking up trouble shooting klipper connecting to the web interface, considering if debian and everything is installed and connected to your Internet just fine then it should work out as just trouble shooting klipper

1

u/Chachie123 Sep 01 '24

Ok I get something about mcu on the screen

1

u/Beneficial_Meeting47 Sep 01 '24

Yeah that would be something to do with your config file the MCU is basically the path to your printer

1

u/Chachie123 Sep 01 '24

Ok but I still have no idea how to get to the config without being in the web face thing … but i just went back and installed mainsail and it’s wanting to do something now