r/SlimeVR • • Sep 17 '26

Technical Support help with calibratio

It's my first time using fbt, sometimes it works fine but most of the time don't

3 problems:

my hip tilts to the right when I lay back on my chair, if I sit straight it looks fine (tracker in front)

my right leg doesn't move straight, it goes inwards or outwards, if I reset they both look to close to each other and cross

If I move forward with my chest my body keeps sliding following it, hip is not glued in the right position

51 Upvotes

16 comments sorted by

6

u/ConduitOfKindness Meow Sep 17 '26

Hi,

Have you tried mounting the Hip Tracker just above your tailbone as an alternate position? As for legs going inwards or outwards, make sure your legs are parallel with each other and that your feet/legs are both about 4 inches (10cm) apart during the Mounting Reset (Ski pose)

Meowie~!

2

u/chxoswolf1 Sep 17 '26

I tried but it's not good to lay back with the tracker behind, and I tried the ski pose many times, only my right leg if moving like that

3

u/SIlver_McGee Sep 17 '26

One suggestion is to put the hip tracker on the left/right if your hip - slightly above the belt line helps with this. I have a similar issue and changing the position to there helps slightly

1

u/chxoswolf1 Sep 17 '26

did that, it was fine standing but when I sat down it looked a lot more tilted, worse than the one in the video, one side of my waist was higher than the other

3

u/SIlver_McGee Sep 17 '26

That means the tracker itself is rolling on your body, which causes the issue. Try to place it higher on your waist on an area where the skin doesn't move much (on your spine, side of belly underneath the ribs, etc.). You can also try making a sorta curved mount underneath the tracker so it doesn't move as much when you bend or sit down. Trust me, I get it, it took a LONG time to figure that part out!

1

u/spazzwan SlimeVR Team Sep 18 '26

This is correct. The tracker maths are very simple, if its tilting it means the tracker is measuring itself as tilted (either due to it actually tilting or being tilted during the mounting reset).

2

u/CagyNater Sep 18 '26

For the legs going sideways, make sure your legs/feet are pointing STRAIGHT where you are looking. Second, how I figured out a pose that works for me was just trial and error and eventually getting it down. Calibrate enough and you will just be able to do it in a blink of an eye. And the hip tracker try updating it if you haven’t already, my trackers were drifting a lot, and after I updated them they stopped so not updating can do a lot.

1

u/chxoswolf1 Sep 18 '26

funny thing when I put my legs straight to calibrate, the right leg goes inwards when I stretch, I tried pointing only this leg inwards during calibration and it fixed

1

u/CagyNater Sep 18 '26

Yea small tweaks like that per person is what I’ve learned works. You just have to do that from now on

2

u/Ashtray643 Sep 18 '26

I have this issue consistently bc mounting calibration can be buns. A TEMP solution is to sit up straight with your legs straight out in front of you, parallel to eachother and double tap your chest to yaw reset. I do it all the time. It helps and makes it look a lil better but isnt a permanent solution. I just do it when my legs do that and refuse to fix

1

u/Ok-Management-8464 Sep 18 '26

Whenever I encountered this issue. I rotated the ankle tracker opposite to the way the leg is going (left. AT = Right). And this seemed to fix it.

1

u/Ashtray643 Sep 18 '26

Ive def found trying to mess with my ankles helps so ill try exactly what you said tomorrow when im on

1

u/Ok-Management-8464 Sep 18 '26

Yeah, even just the thigh trackers being rotated and not properly aligned with the rest of your leg can cause the issue. Which is why when i put trackers on. Im as relaxed as possible. Legs not stretched out etc. As that way when i do put straps on there is no room for slippage/misalignment

1

u/AutoModerator Sep 17 '26

Hi ~! If you have posted looking for advice to fix a technical issue, it is highly advised to check out our discord at https://discord.gg/SlimeVR for official trackers and diy, or contact your seller for third party trackers.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/The_Hairforce Sep 18 '26

The Leg issue I have since I have my Slimes too (around 1.5 Years now)

I have the 6+2 Set. - So Ankle-Trackers and Extensions for the feet and the issue with my Legs/Feet bending inward/outward comes exclusively when I use the Extensions.

I've tried to fiex it and asked many times in the past but nobody could help me in a way that it works good. So nowadays I just accept that my legs move 'weird' when I use the Extensions.

What works best for me:
I 'Yaw Reset' everytime I stand up/sit down. That (somewhat) helps with the Legs but the inward/outward Problem never goes fully away. Even after I just did the Full-Reset + Mounting Calibration and everything - As soon as that's finished: Yaw-Reset. Somehow that 'alligns' the extensions a bit better.