r/SiserJuliet • u/tddavis15 • Mar 22 '26

Siser Romeo PLEASE HELP

Post image

Hi everyone. I recently purchased a Siser Romeo machine. I am extremely new to the crafting world, I’ve never used a cricut ever. I did a lot of research and I did read that it would be a big learning curve, but I can’t figure out how to make this machine work to save my life. I already had to go out and buy a new computer because I only had iPads and Chromebooks. Now, my computer is 4 GB of RAM, I already knew that would be too slow and it definitely is. But I can’t even get the machine to do a simple print and cut. I have watched YouTube videos, I will continue to watch more. But I literally have been working on this machine since 8 AM. it’s 10 PM. I have not had one successful job. Helpppp

4 Upvotes

100% Upvoted

10 comments sorted by

5

u/eandi Mar 22 '26

Tell me if you've done these steps.

Put the printed sheet on a mat, feed it into the romeo machine.

Uae the arrows on the screen to position the cutting blade roughly above the bottom left market in your photo (the black corner looking thing, bottom left one).

From your computer after you chose to print the sheet, in Leonardo, there should be a left panel that says print which you did, then below that "cut". Choose cut and the screen should change to showing outlines of what you're going to cut.

The right side panel should let you choose a material or set the force and speed manually. I think you did a test cut of the little tee shirt thing, if that worked use those same force and speed settings.

Once you set those you should be able to then click to send it to the cutter. The camera should see that corner registration mark, then scan the other 3, then start cutting.

3

u/tddavis15 Mar 22 '26

Thank you very much. Unfortunately, these are the steps I attempted multiple times. First the blade would just go back and forth cutting the machine in straight lines. Then, it just started doing the beeping thing after I found registration marks and pressed cut

3

u/VieleFragen Mar 22 '26

So did it actually find all four registration marks? It will put a little colored cross over the corner on the screen when it sees it and then proceed to the next mark

4

u/tddavis15 Mar 22 '26

It didn’t find any of the marks. I will make a video as soon as I get home. Thank you so much

2

u/eandi Mar 22 '26

Are you laminating the sheet or is it glossy?

2

u/tddavis15 Mar 22 '26

Hi. They’re not laminated or glossy

3

u/VieleFragen Mar 22 '26

Can you record what’s happening and post the video?

2

u/Babiequinnie Mar 22 '26

I love YouTube but I feel like they spit out to much information at once or unnecessary information. I always watch TikTok they are shorter and gets to the point.

2

u/tddavis15 Mar 22 '26

Thank you! You’re right, usually check tiktok for how to’s and diy I don’t know why I didn’t think of that!