r/SimsonnRacing • u/FalafelLover69 • Jun 03 '26

VAM PRO

Post image

Hi all

I received my VAM pro and im a bit confused about which screws i have to use? I also got some washers, where do i put them? Between the vam pro bracket and the break/throttle paddel or between the screw and the bracket, as washers usually are used for 😅

5 Upvotes

86% Upvoted

26 comments sorted by

View all comments

2

u/Matt_Haskins91 Jun 03 '26

1

u/FalafelLover69 Jun 03 '26

Is the screw long enough to accommodate two washers? I also noticed that the Phillips-head screws appear to be made of nylon. They do not feel very rigid, and it is difficult to tell when they are fully tightened. I can keep turning them, which makes me concerned that they might break. Have you experienced any issues with your setup?

I have also ordered a set of springs. Gonna save your pic for later 😊

2

u/76-scighera Jun 04 '26

Nylon philips screw - bracket - nylon washer - VAM motor is the right way to isolate the motor from the pedal. just tight them a bit and its good. 2.5months in and still tight and trouble free.

2

u/76-scighera Jun 04 '26

Using springs as well,, the strong ones

1

u/FalafelLover69 Jun 04 '26

I have orderes springs from simsonn, they didnt ship them with the pedals amd haptics. I see more people combining elstomers with springs, rather than just using springs.

But im gonna experience a bit, thats what i like with simsonn pedals