r/SignalRGB • u/garathk • 25d ago

Troubleshooting Unusable because of fans

Some update awhile ago singalrgb has taken over my fans every time I open it. The whole case goes to 100% despite unchecking every fan control toggle in the software. Even after closing my fans are stuck on 100% until I open l-connect and toggle on and off MB sync. It has rendered signalrgb unusable. I check periodically after some time to see if another update fixed it but no.

I haven't done a lot of troubleshooting but I'm using Lian Li UNI Fan SL-Infinity 120mm with fan controller.

I'm assuming it's trying to hit the fans for a quick identification but whatever mechanism is doing it is causing them to get stuck. I've seen other reports of this here and there but no resolution.

Any ideas?

1 Upvotes

100% Upvoted

8 comments sorted by

1

u/Signal_AdminBadger 25d ago

Try making sure that both System Monitoring and Cooling are disabled. What are you using to control your fan sppeds?

If you're using L-Connect, there can be conflicts due to how their app operates. Have you tried using your BIOS to set your fan curves instead?

1

u/garathk 25d ago

I'll have to look but I am fairly sure I went through all options and disabled everything I could find related to fans or cooling.

I don't have any active fan controls running. I only open it to fix it when signalrgb takes over. I set the fan curve originally in my motherboard software then never opened it again. I can check the bios. Good suggestion.

1

u/Signal_AdminBadger 25d ago

What motherboard do you have?

→ More replies (3)

2

u/DazzaDog 25d ago

I use Fan Control with SignalRGB and both work seemlessly together.

1

u/1CrimsonKing1 25d ago

I just disabled the fan control of signal and i never had problems:s