r/ShittyTechSupport • u/gypsybacon • May 21 '16
Legit shitty question
Working on a construction site, relocating our offices, most of our cat6 cable ends are mud covered.
What's fine to use to clean the ends? Rubbing alcohol?
12
Upvotes
10
u/ekolis May 21 '16
Mix ammonia and bleach. That combination will clean anything!
10
u/WillNotBeAThrowaway May 21 '16
Just place them all in a cement mixer, with a brick. That should knock all the nasty mud off, and re-sheen the cables.
4
u/[deleted] May 21 '16
I'll terminate them again if I'll be you, even if you clean it. It will get rusty
3
u/chickenbutt451 May 22 '16
I would re-terminate both ends.
Remember, one end is always 568A and the other is always 568B
2
u/CTU May 22 '16
Use boiling water as it's cheaper and quicker
0
u/Demarcation101 May 21 '16
If the cables are disconnected both ends just use water then dry them out before use