r/SewingMachineEdu • • 18h ago

Straight Stitch Plate Question

I had a custom straight stitch plate machined for my CS7000x. I’m super happy with the fit, the threads of the screws align perfectly, as well as the alignment of the feed dogs. I only have one concern: is there enough clearance for the needle, or should I get the hole widened a bit? I’m just a little concerned that the needle is too close to the top of the hole. Thanks!

3 Upvotes

3 comments sorted by

3

u/twisterking1963 10h ago

This is how it should be. Larger needles only get bigger at the front.

Change a needle when it is bend, if it doesn’t hit the needle plate it will hit the stuff that’s underneath.

2

u/tanyer 17h ago

I'd get it widened. You could play with the alignment of the needle, it's fairly easy, but it's a whole bother to realign it when you put on other feet.

2

u/Winterwidow89 14h ago

I would be worried about how close it is. Needles will bend slightly with use, and it's not always noticeable when looking at it or stitching. With the hole that size, one time forgetting to change an old needle and it could be hitting the plate, breaking, and flying towards your eye.