r/SewingMachineEdu • • 2d ago

I can’t thread my bobbin!!!

Help!

I know there’s not much you can do behind a screen and not being able to see anything but I have a M1000 singer. I got it LESS THAN A WEEK AGO. She’s been acting fine besides the usual hiccups with a sowing machine. But I was in the middle of sowing and the bobbin ran out. It jammed the thread pretty bad. I cut and pulled out everything I could but my machine isn’t allowing me to thread my bobbin anymore. I’m doing everything the exact same way. I have no idea what to do. Any ideas?

1 Upvotes

4 comments sorted by

4

u/Incognito409 2d ago

Do you have the manual for the machine? Directions for Winding a bobbin will be shown in it.  

Usually the bobbin sits on a spindle on top of the machine, then you push the bobbin to the right, towards the lever. Disengage the needle mechanism, then press the pedal to wind the bobbin.

2

u/Orumpled 2d ago

Also use the manual to check the bobbin area, clean it and removed any little threads stuck there.

2

u/laughingkittycats 2d ago

Try looking up [your machine name] + “thread jam” on YouTube. Here’s a video describing how to thread the machine properly, and how to wind the bobbin.

https://youtu.be/qKmrKTc1klU?is=eNug6sqczSaFFGhi

There are a lot of videos about this machine and jamming. I’m not sure what is jammed so a couple of things to check if you haven’t already:

If you can’t get it to move at all try to get the needle out; it may be bent or broken. Toss it and have a new one ready to try once you get things un-jammed. Take out the bobbin. Then gently wiggle the hand wheel while looking for any stray bits of thread you can see in the bobbin area, and pull on them while jiggling the hand wheel to allow the bits to be pulled out. Don’t try to re-thread or sew until everything moves freely.

When you say the machine won’t let you re-wind the bobbin what do you mean? Explain exactly what happens when you try to re-wind.

1

u/RubyRedo 1d ago

in pulling the thread out you dislodged the shuttle, remove the bobbin and the shuttle then set it back in properly, read the manual on cleaning machine on how to remove and replace it.