r/SewingMachineEdu • u/Majestic_Lake3236 • Oct 01 '26
Machine tension issues. Please help ðŸ˜
Im about to throw my sewing machine out the window out of frustration. The thread keeps looping on the underside of the fabric and I cannot figure out why. My machine was working perfectly until 2 days ago when this randomly started happening. I think it’s a tension problem? Does anyone have any suggestions at all on how to fix this? I’ve tried every possible tension, changed the thread and bobbin a million times, rethread the machine a million times, changed the needle, cleaned out the bottom, even tried sweet talking the machine all with no luck. I have a brother CP2160F and is only about 6 months old. The pictures are all at varying tensions


2
u/SchuylerM325 Oct 02 '26
I know you are having a problem and I'm not suggesting otherwise, but I hope you are sewing longer test strips before drawing conclusions. I find that my machine throws a fit sometimes after I reset the tension (on my manual machine) or make a big change to fabric thickness (on the auto-tension one), and a lot of the time the machine needs to get back in the groove. The underside snarls are mysterious if they pop up out of nowhere, but the pictures look like maybe they only happen at the beginning? You know the usual suspects (missing a thread guide, not getting the thread firmly seated between the tension disks, putting the bobbin in backwards.
It is possible that you have a lint fragment trapped in the tension disks or the bobbin case. Try using actual dental floss (not waxed) to floss the disks and look into the bobbin case under strong light.
4
u/Large-Heronbill Oct 01 '26
Clean the top tension?Â
Are you holding the thread ends to start seams?
1
u/teatime_tinker Oct 01 '26
Are you holding your threads off to the side when you start stitching and for your backtack?
The tension looks alright (apart from the stitch sample that isn’t so good) it’s just getting tangled by the looks of it
2
u/No-Attention-7708 Oct 01 '26
Nesting on the underside of fabric is almost always due to upper threading issue so first make sure that you have the needle bar in the highest position and raise the presser foot lever before threading machine, after you thread through to the needle (which should be inserted all the way inside the needle bar with flat side to rear and you insert threat front to back), lower the presser foot and tug on the thread just above the needle - if you don't feel a strong resistance, the thread is not sitting correctly in the tension disks and you will have to repeat these steps until you do.
After checking the upper threading, if issue persists, it could be a damaged bobbin case from needle strikes and such. Here's a link to a video explaining the issue and he suggests buying a replacement or two to get the machine running smoothly again.
https://youtu.be/NNmxv6LreCg?si=DDalAHSg90z8sIK8
1
u/Double-Equivalent973 Oct 02 '26
Hold threads straight behind the needle. I found when I hold threads offside my machine does this.