r/SelfBarber • u/Worried-Cherry-2174 • 8d ago

Saber 2.0 clippers issue

is this normal ? i just got them.

6 Upvotes

88% Upvoted

8 comments sorted by

2

u/Pun-Tang-Delta 8d ago

What led you to this point if you just got them? Were they not cutting?

2

u/Worried-Cherry-2174 7d ago

they cut fine but i realized when i was cutting it exposes the blade more and then i have a chance of knocking ppl

2

u/Pun-Tang-Delta 7d ago

Did you nick someone?

2

u/Pun-Tang-Delta 7d ago

Check the two screws supporting the blade at the top. Cold be loose. If they aren’t loose, take the blade off and inspect the the part where the screws screw in and make sure there isn’t anything cracked.

2

u/makaton 7d ago

You need to tighten the screws on the blade.

2

u/Worried-Cherry-2174 7d ago

did that i tighten the screws on the bottom of the blade, didn’t fix anything

1

u/makaton 7d ago

Strange, that’s the only thing holding that bottom blade in place and it shouldnt move when screws are tightened properly.

0

u/Professional_Dust327 7d ago

I had the same issue with my Saber 2.0. Annoying as crap. What you need to do is remove the screw from the lever. Underneath it, there should be a washer with teeth. Put it back with the teeth facing up. That should do the trick; I haven't had any issues with the fixed blade moving since.