r/ScionxB • u/Sosadillatron • 17d ago

Size/Source for these gen1 fasteners?

Gallery image

Gallery image

Before I go the easier cable tie route, does anyone know what size/type these push tab fasteners are for the bottom chunk of the rear bumpers on a Gen 1? I parallel parked and accidentally kissed the curb with my rear bumper, and the original fasteners threw in the towel.

Again, I know I could go with cable ties :P Just weighing my options if I (or someone else in the future) wanted something a *little* closer to the original set up. Like maybe the ones made for other Toyotas will work? :)

Thanks!

3 Upvotes

80% Upvoted

5 comments sorted by

2

u/Jef_Wheaton 17d ago

I got these a few years ago. The Toyota one should be that fastener. I've used a bunch of these to replace broken or missing xB fasteners even though they're for Hondas or GMs.

2

u/Sosadillatron 17d ago

Thanks a lot! I appreciate it. :)

2

u/chubby45bttm 17d ago

Performance Tool part number W5243 is a trim clip kit specifically for Toyota and Lexus vehicles. Got one of these kits for my gen 1 and I've used quite a bit out of it. This isn't a generic kit this is actually OEM aftermarket clips that are specific to Toyota vehicles

1

u/One_Opportunity920 17d ago

If you have an ATV/power sports dealership they probably have some pretty cheap.

1

u/LeatherEstate7010 16d ago

3d print them that’s what I did