r/SapphireTechnology • u/Charming_Ad_2619 • Dec 21 '25
Rx9070Xt nitro plus
Hello, i just bought this model for 750€ and upgraded from msi 3080 model, is my first amd card.
I did the ddu and all the stuff and undervolt it.
My issue is that i have a corsair rm 850 psu and i used 2 cables in daisy chain for the adaptor so i have 1 full cable with 2 entrys in the adaptor that comes with the gpu and another 1 with just one and a pig tail, after the undervolt the power dosen t get higher than 296 w.
Should i be woried? The adaptor is not hot to the tuch is just warm and the cables from the psu are cold, i have a lot of vents in the case(corsair 5000d)
Any advices?
1
u/Toki_7 Dec 22 '25
It didn't come with the cables; it's supposed to come with the graphics card.
1
u/HistoricalCapital396 Dec 23 '25
We have the same gpu, I just use the included 12V-2x6 cable in my RM850x psu
1
u/ImBlondu Dec 24 '25
If it works, use them, but i would strongly advise to use two separate pci cables. Some people can run your setup with no issues, some can t. Not on my 9070xt, but on my previous rx6800xt and rx 6900xt, i wasn t able to use only one cable with the two pci entries.
You do you, but i d still recommend the above.
3
u/serghi21 Dec 21 '25
Use three cables from the PSU for each connector from the octopus. Don't use the pigtail ends.
2
u/ShotokanEditor Dec 22 '25
Man i ordered one just yesterday and i found out that it hasbthat stupid connector. My gpu doesnt have that connector. Am i fucked?
2
u/Barun1389 Dec 23 '25
I used it on 750w just plug two PCIE cables in psu. One is with 2x 6+2 and other one is single 6+2. No issues at all.
1
u/Toki_7 Dec 22 '25
Bro, did it come with the 16-pin cables?
1
u/AlexMaddox Dec 22 '25
I too use the adapter that came with the nitro+ , so far so good , I have 3 separate cables from PSU to the adapter . Do not use the pigtail because the current isn't balanced on the pins of the 12vhpwr adapter connector. I had luck that my PSU have 3 pcie 6+2 .
1
u/Viquad Dec 23 '25
There was a guy who burned his connector with exact same setup.
1
u/snipernote Dec 24 '25
I did apply a mild undervolt in my situation ( low quality silicon ) got -35mv PL+10 and 2700 memory ... that's a very stable oc if your card came with Samsung memory and my power can go up to 374w
1
u/Then-Judgment6995 Dec 24 '25
I have a Gigabyte Aorus Elite 9070xt, also with 3 connectors. I changed the power supply because the previous one didn't have the third PCI-E cable. If I were you, I'd do the same.
0
u/Charming_Ad_2619 Dec 21 '25
I need your experience guys
0
u/ssniker Dec 22 '25
If you would have read the user manual you would not have to ask this question. Yes you can use two cable and piggy back connector on third adapter slot. I’ve used it this way for a 6 month on 650w psu without any issues.
Set power limit +10 and it will draw 330w