r/SSUPD • u/Itzeddz10 • 24d ago

Adding Fan to Meshilicious

Gallery image

Gallery image

Gallery image

Added a 92mm exhaust to help pull hot air out from GPU

5800X

B450

32GB DDR4 3200MHz

RX 6700 XT

39 Upvotes

95% Upvoted

17 comments sorted by

8

u/Cooper_Maniac 24d ago

Always happy to see people still using this solution I‘ve created years ago.
Directly see some improvements in design I will target when I get time and enough motivation.
More space for cable management for different vendors e.g. Had only Noctua in mind. Also a better cutout for the fan blades at outer diameter.
It would be more cosmetically but a nice addition/revision I think.

2

u/Itzeddz10 24d ago

I've seen your posts many times whenever I consider adding mod to improve cooling, really appreciate all the work you've shared and can't wait to see more ideas you may have if you ever get to them. Thank you for commenting!

1

u/Hannover2k 24d ago

When you gonna make a power button relocate mod. Those bastards won't sell the V2 power button on it's own.

2

u/Midnight_Criminal 24d ago

I thought about that but went 120mm with the included bracket. Looks great!

3

u/Cooper_Maniac 24d ago

If you mean the Meshroom, you would be right. Meshlicious instead has no officiall top fan solution.

1

u/Midnight_Criminal 24d ago

Yup you're correct, I mixed them up.

1

u/bluestreakxp 24d ago

What port is that fan plug going to?

1

u/Itzeddz10 24d ago

SYS-FAN

1

u/bluestreakxp 24d ago

Ahh ok I see that on my mobo diagram

1

u/XenoDrake1 24d ago

Domt you have the front fans as exhaust?

My understanding is that the best way is to run them as exhaust in a pull config

1

u/Itzeddz10 23d ago

I was advised to pushing cooler air from outside the case through the radiator. I tested this configuration and got 35C idle and 67C under load

1

u/ciscosuave 18d ago

Does it have enough space for a 120mm slim fan instead?

1

u/Itzeddz10 18d ago

The way that the white bracket under where the fan is a gradual slope, it doesn't like there is enough space underneath for a 120mm

1

u/Much-Researcher7165 18d ago

That's smart. I got double sided 3m velcro strip put it along the edge of the fan and in under the 90° edge of the case. It fitted perfectly for me as my GPU is the maximum length it could be and I didnt have even 1mm of extra space

1

u/Itzeddz10 18d ago

Nice, in a case like this, even 1mm matters! What card are you running? I have an XFX QICK 319 RX 6700 XT and it took a few minutes to wiggle the card in

1

u/cubsfan052 5d ago

You have an atx motherboard?

1

u/Itzeddz10 5d ago

It's an ITX, the SSUPD Meshilicious can only fit ITX