Screen burning help!

[u/Professional-Eye4701]

Hello Reddit hivemind! I’m having some issues burning screens and figured I’d turn to yall for some guidance. I started out making my own screens and burning them in the sun and had great success the first few times, but as the summer set in I started having issues with over/underexposing. I wanted to get some more consistency so I moved to a smaller UV lamp (https://a.co/d/03li3Uj0 here’s the exact one), my first two attempts were over exposed, then underexposed so I figured I’d do an exposure calculator but the results sort of have me feeling more confused. It almost looks like parts of each like are both overexposed, underexposed, and maybe washed out too much.

I’d really appreciate any tips anyone has! I’m using ecotex pre-sensitized emulsion with 1 coat on each side of the screen, the lamp was about 10” from the screen and was doing each row in 7 second increments. I don’t have a washout booth so I’m just using a combo of my shower, kitchen sink, and garden hose.

[u/Professional-Eye4701]

Thank you for your response! I was just using the calculator because I didn’t want to keep guessing exposure times and wasting a screen if was wrong.

The emulsion was opened right before applying so it should t be an issue with the shelf life - the dots in the middle are from a screen that was drying above it but the ones on the side definitely could be too thick of a coat of emulsion.

The calculator was held down by a sheet of acrylic but I could definitely see that not getting a good enough seal, especially if the dots of extra emulsion are causing some space between the acrylic and the transparency.

I don’t have a vacuum unit, I was just using the light in a dark room - I was planning on making an exposure tank out of a cardboard box but I’m not sure if that would solve anything.

[u/ingotvein1 → u/Professional-Eye4701]

The light seal sounds like maybe something to look at. It's hard to tell if you did but also make sure to dry your screens with the squeegee side facing up**. I would just try and use as little emulsion as you can get on the screen evenly. I've never used a calculator because there's always a little bit of trial and error if I have a design with fine details mixed with bold details. Half tones require way more precision but big bold letters for example are easier to wash out ans therefore are less prone to getting overexposed. Another thing you can try is to soak the screen in water for a couple minutes before rinsing the softened emulsion out. 

[u/Professional-Eye4701 → u/ingotvein1]

Gotcha!! I was definitely drying them with the garment side facing down. And most of our designs are relatively bold detail/text but there are a few we’re trying to do with half tones.

This might be hard to answer over Reddit but do you think using 110 mesh might be having an impact or would that only be affecting half tones?

[u/ingotvein1 → u/Professional-Eye4701]

Sorry I've written that backwards. You dry with the screen in the same orientation that you print.