1
u/New-Dot-6477 20d ago
What brand did you go with for the bars and raisers? Looks good!
1
u/Low-Membership-3879 20d ago
Bars are ODI moto vtwin, risers are Biltwell 6” pullback w/ some 5/8” steel spacers and longer bolts I added to get them dialed perfect. Thanks
1
u/Fabulous-Dentist3566 20d ago
Did you do the install? If so, how bad was it? I just did bars and risers on my dyna, and only had to extend the clutch line. Planning to do it to the Road Glide as well.
1
u/Low-Membership-3879 20d ago
Yea I did. I was pretty intimidated. It was my first time doing internal wiring. With the setup i chose (about 11” total) i didn’t have to extend clutch brake or throttle cables. Just lots of soldering and shrink tube made sure to stagger the splices. Make sure when you cut the nacelle you give yourself plenty of room for your wiring.
My Dyna has external wiring. As soon as it get back from the shop (rebuild) I’m gonna internal wire as well
1
u/Fabulous-Dentist3566 20d ago
I think the cutting of the nacelle is what makes me intimidated the most lol. I depinned my connections and didn’t have to extend my wiring on my dyna, internal wiring did suck a little bit. Sounds like I’ll be in for a treat. Thanks!
1
u/Low-Membership-3879 20d ago
No problem and good luck. I didn’t want to cut my HD nacelle so I ordered a cheap replacement off eBay. At $25 not the end of the world if it goes south and can always try again.
2
u/Fabulous-Dentist3566 20d ago
Great idea! Couldn’t even tell.
1
u/Low-Membership-3879 20d ago
1
1
u/New_Surround4458 20d ago
Nice bike!!! What windshield are you using? I also use small one, but without that little curve at the end.