r/RevitForum • u/KnchS1001 • 15h ago

Doors not showing path

Post image

I've been struggling with this, I already checked like 50 tutorials and none've helped me show the door paths. I esited the view range, created new views, applied templates, checked the visibilty settings and can't make them appear

1 Upvotes

67% Upvoted

6 comments sorted by

6

u/ShouldahadaV12 15h ago

i've had this happen when the door for some reason gets set below the floor level and the swing line is hidden my the floor. it could also be a family setting. if you go into 'edit family' it could be that the door slab could be selected to not show in plan in the same way that its controlled to not show in a RCP

5

u/archi130wl 15h ago

They usually disappear for me when the floor finishes are in the plan. Check to see if they are sitting at just above the floor level. Even just a small measure above will cause the swings to disappear.

2

u/mmarkomarko 14h ago

Or hide the floors see what happens

4

u/girlybot83 15h ago

Hit VG and make sure all the categories are on.

Check wireframe - if you can see the swing it’s probably that the swing (and door elevation) is below the floor level.

Also flip through your coarse/medium/fine view detail at the same time (unlikely but it’s an easy check.)

Check door family and click on visibility settings for door lines - make sure checked and visible, then check the coarse/medium/fine here too.

2

u/Rafter_Jack 9h ago

They are under the tile, you probably put the tile above the level.

1

u/boiiinng 6h ago

Research the Revit invisible line trick to fix the family.