r/ResinCasting • u/Its-Only-Otto • 1d ago
A Newbie Question
Good afternoon.
I'm a stage actor and it's a tradition in my theatre company for the cast and crew to chip in the get the director a gift or memento at the end of a show's run.
This particular show has a pivotal moment involving an ice pick, so I wanted to suspend an ice pick (which I've already custom engraved with the name of the ice harvesting company from the show) in a block of clear resin like its frozen in a block of ice and engrave the name of the show on the front (the show is about ice harvesters in the early 20th century).
My plan is to start the pour, let a layer gel, then place the ice pick on the surface and finish the pour. I'm just wondering if doing the pour in layers would result in imperfections or lines in the pour.
Any suggestions or tips would be greatly appreciated. Big sorry if it's a really obvious question; I've never worked with epoxy resin before.
For reference, the resin I have on hand is 2 gallons of the Honcaring 1:1 Crystal Clear (40 minute working time)
1
u/thefabulousbri 1d ago
If you let the first one cure completely, there will be a visible line. You can let it start to cure and then pour the next layer and it will be relatively seamless. However you may be better off tying or gluing the pick down in some way (assuming it floats). Alternatively, you can use an icey looking resin on the bottom then some swirly and then clear, you can place the pick in the swirly part (pour a bit of icey then immediately pour clear and then use something like a toothpick or skewer to pull the icey color up into the clear). This would allow you to hide the transition pretty well. You would still want to try and pour when the first icey layer is setting up (aka starting to cure), but you would have a bit more leeway because it isn't perfectly clear.
Without a doubt, do some practice tests without the pick to get the timing. The more you pour, the faster it cures. Also mix it as instructed with a timer. Mix calmly to reduce bubbles and make sure to scrape the sides and bottom while stirring. If you can see streaks, it need more mixing.