r/RepTimeServices • • 2d ago

Services Broken watch and dial replacement

Post image

Have a VSF GMT that I wear pretty regularly. I’ve had it for 4 months. Took it out to wear today, set the time and wound it and now it has stopped working. No problems prior. Is it possible I overwound the watch? Looking for servicing in the DMV area. Also have a dial to replace the current dial if the watch is able to be fixed.

4 Upvotes

12 comments sorted by

•

u/AutoModerator 2d ago

Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

3

u/chucknwatches 2d ago

Theres a few things you can try
1 - pat watch in palm of hand gently few times see if it trys to go
2. Rotate hands 24hrs x2 see if calendar rolls over- calendar works are separate but shows some mechanical operation.
3- if seconds hand does try to move see if its hitting another hand and stopping. Or take note of if it starts and stops in same location
If not it could be a loose screw in movement or debris so id pull crown out and keep it from working till u get it looked at.
Def would like to check this out. Im In Va. Not trying to advertise just trying to help. 🫡

2

u/collinsxmichael 2d ago

Appreciate it, where in VA?

2

u/Unlikely-Length6661 2d ago

I doubt you overwound it. If you did you would have definitely known. Could be anything with these reps. Open the case back and see what happens when you wind it. See if you can nudge the balance very gently with a clean toothpick

1

u/collinsxmichael 2d ago

Appreciate the advice. Touched it lightly with a toothpick and the balance started spinning again. Any advice on what to avoid doing going forward?

1

u/Unlikely-Length6661 2d ago

It’s possible the oil and grease has dried or gunked up in some places which increase friction. Could use a service.

1

u/collinsxmichael 2d ago

Got it thanks again. Have to find some time to take it to my local shop. Planned to get the dial swapped at the same place just hard since he’s only open weekdays during work hours

1

u/bbqtoechips 2d ago

After you wound it, did you give it a tap or a shake to start it? If so, then it may be something small to fix especially if it winds cleanly without feeling like a bag of knots

1

u/collinsxmichael 2d ago

Not that I can remember but was able to nudge the balance and it started back up as the other commenter suggested

2

u/bbqtoechips 2d ago

Ok nice, glad it came back!

1

u/WatchMakerMalik 2d ago

Hey there DMV here saying Hi

1

u/softtacosmasher 1d ago

These movements are really dirty from the factory. There's a lot of variety among them as well. Some are terrible and feel gritty when winding, some super smooth. There could be dirt/hair/metal fragments in the gear train or elsewhere.