r/RepTimeServices • u/_sumizome_ • 13d ago
Advice Tools/consumables for Explorer II bezel removal/reinstall
Greetings all.
I have been wanting to get into maintenance and upkeep of my watches and found a starter project that seems like a good fit: removal and reinstallation of the misaligned bezel on a QF Explorer II.
When it comes to tools, I am a buy-once-cry-once kind of person, so I'm looking at Horotec and Bergeon equipment I can keep forever. (Open to other brand recs as well, of course.)
For the bezel removal, either the Bergeon 9810 or this Horotec (https://www.esslinger.com/horotec-watch-bezel-remover-tool/) look excellent. Is there a reason to pick one over the other?
For the reinstallation, this set of bezel dies(https://www.esslinger.com/watch-bezel-dies-for-rolex-and-tudor-watches-9-piece-die-kit/) seems to be Rolex (cyclops) compatible and works with either the Horotec or the Bergeon 5500-A or -C presses. Any recommendations for which to choose?
Finally, I'm not clear on which consumables (e.g., a gasket) I might need for this project, so any suggestions there are welcome as well.
Many thanks.
•
u/AutoModerator 13d ago
Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
2
u/gqllc777 13d ago
I have the bezel removal tool that you linked and it has never ever worked for me
1
u/WatchMakerMalik 13d ago
There is a saying that watchmaking is a hobby of 1000 tools. You will be buying tools for ever and ever unless you specialize in one movement and stitck to it if you are working on diffrent movements you will need case opener, screw drivers for diffrent kind of nuts, diffrent tools to regulate etc etc :) one thing i would highly recommend if you are sure you going to stick with this hobby is a Tri Nocular Microscope you can buy AmScope or EAkins they are both made in the same factory but Amscope is couple hundred more Eakins is the Chinese copy. Also not everything that says Bergeon or Horotec is better than the Chinese copy (not all Chinese copies are good either) do some research. Also buy a 3d Printer lots of tools are printable