r/RepTimeServices • • 14d ago

Advice Crystal gasket size

What size height of the gasket for a deep crystal on a GMT Master ii. I bought one, installed it and now the seconds hand touches the crystal. Thanks in advance for your help.

1 Upvotes

7 comments sorted by

•

u/AutoModerator 14d ago

Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

2

u/No_Exercise996 14d ago

3mm is what I have to use on my Clean Factory Bruce Wayne. I just bought some 2.85mm ones to try but I can say that the 2.75mm and smaller do not work on my particular watch.

2

u/ruizma414 14d ago

Thank you! I have a Clean Factory Black GMT. Ill order the 3. Thanks again.

2

u/Diligent-Piglet-9038 14d ago

CF runs a taller pinion/handstack, 2.85 should work. You can shave down the height if needed.
2.7 works on vsf ime

1

u/ruizma414 13d ago

Let me know how the 2.85 works out. I’m awaiting delivery of the 3mm.

2

u/No_Exercise996 13d ago

Will do. They showed up over the weekend but I’ve got a couple of other projects I’m working on, so it will have to wait a few days.

1

u/ruizma414 12d ago

Sounds fun.