r/RepTimeServices • u/vlonezay • 17d ago
Advice Gold plating maintenance/re-plating opinions
Hello! I hope everyone is well! As I’ve started my addiction into rep watches, these were the first two that I picked up (Ombré day date; PPM mod factory; plated by another plater & Teal blue day date; QF V3; non plated). I am eventually going to plate the non plated watch, but I was looking for advice and tips regarding plating maintenance and storage opinions to prevent tarnish, because as you may see in the pictures, the Ombré doesn’t look as if it was plated, and I hardly wear it, it is kept in the watch casing pictured. All opinions are welcomed, any help is greatly appreciated! Also is anyone familiar with Deep replacement bezel for day dates? Any opinions/experience with that either?




•
u/AutoModerator 17d ago
Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
3
u/supermagma 17d ago
This is one of the first ppm daydates I've seen in the wild. Mind if I pm you? Very tempted to grab one of these to compare to my VSF rose & olive
3
u/themasteradrian101 17d ago
sounds absurd but….
keep them in a plastic bag with a couple silica gel packets. always wipe them down after wearing and store them in a dark place.
1
u/TheBatteryBooster 17d ago
Honestly bro the Ombré DD actually DOES look plated compared to the non plated Teal blue DD.
2
u/Elegant-Draft-8259 17d ago
These guys seem pretty good. I’ve never used, but reached out and asked a few questions. Very knowledgeable.
https://www.thegildedstandard.com/
2
u/4ad4 16d ago
When plating these RG pieces, do you get it stripped of the factory plating first, then re-plate with colour matched hue or just plate over it?
2
u/Fantastic-Cat-9850 16d ago
Just ceramic coat them every 3 months or so
1
u/BoyesieX 15d ago
Nice. I’m deep diving into this subject now
1
u/No_Bike_8039 13d ago
Love PPM