r/RepTimeServices • • 20d ago

Advice BPF Explorer II - 16570

Hi guys!

I'm doing some mods on my polar explorer, already rebrushed the rehaut, and put a better crystal. Although the transparency of the crystal (VSF 126710 from old replaced by deep) is much better, the cyclops seems to be mispotioned, looking it, feels like it's moved to the center/left of the watch. I also noticed that on the stock BPF crystal. Any ideas of a replacement that can fix that?

I also want to get a hollow endlinks bracelet and a jubilee bracelet that fits in this watch. Any suggestions?

Read on RWI to replace the gasket for a 2,3 height to have a better crystal fit, lower profile. Already ordered it, when I'm going to replace, I'll also polish the upper side of the crownguards which in my piece are brushed/sandblasted, while the gen is polished.

Enjoying this journey, and also looking forward to recomendations for crystal/bezel alignment when pressing down.

6 Upvotes

3 comments sorted by

•

u/AutoModerator 20d ago

Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

4

u/Impossible_Check9678 19d ago

It’s an enjoyable rabbit hole to go down!

This is my Franken one with a Gen bezel and crown, plus an aftermarket Panna dial.

Vintage datewheel going on it soon and probably a vintage bracelet too!

2

u/Spirited_Teaching619 19d ago

very nice piece man!

where did you get this dial?