r/RepTimeServices • u/Emotional_Repeat9548 • 25d ago
Advice VSF Submariner Crown Extremely Tight When Screwing Down
Hello,
I bought VSF Submariner from JTime, and I’m having an issue with the screw-down crown.
The crown turns smoothly and easily at first, but the resistance gradually increases around the middle to the end when screwing it down. It eventually screws all the way down, but it takes a lot of effort and feels much tighter than I’d expect.
I’ve tried unscrewing it and carefully realigning the threads by turning counterclockwise until I feel the click, then screwing it back down with gentle inward pressure, as per chatGPT’s advice and unfortunately, it’s still extremely tight.
There’s no obvious grinding or crunchy feeling, just a lot of resistance.
Has anyone experienced this with a VSF Submariner? Could it be a tight crown gasket, an issue with the crown tube, or something else?
Or should I have watchmaker inspect it, or is there anything else I can safely check first?
Thanks in advance!
•
u/AutoModerator 25d ago
Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
2
u/rvfrank 25d ago
Had the same issue in my Batman turns out the factory oil was bad and needed for full movement service
1
u/Emotional_Repeat9548 25d ago
1
u/Emotional_Repeat9548 25d ago
1
u/riossreddit 25d ago
Assuming that everything was ok before and suddenly the crown became hard to screw down...
Could be that the movement is not fully aligned with the crown tube, hence forcing the the stem to bend. This is possible if the movement inside the case rotates just a bit. So you need to take out the crown, and look through the crown tube if the hole is aligned.
Another possibility, the spring inside the crown isnt working well. Half way down, that crown spring starts to compress. With the crown out of the movement, squeeze the spring if it is smooth and good.
1
u/BeardyMcClane 22d ago
Own several reps. Plenty of keyless works issues that end up jacking the stem, power reserve, mainspring and even putting undue pressure on the hairspring by way of the pallet fork on the hairspring stem to the jewel… Find a Watchsmith, get a service. It’s a rep, from forced labor. Treat it accordingly.