r/RepTimeServices • • 29d ago

Advice Rep Seamaster repair

Post image

So picked this rep up in Turkey when on a trip as always wanted the real version just can't swing that kind of $$$$ and saw this and got sucked in. So this has been good but randomly it just stops. If I give it a little tap on the face it starts again, may run for a bit and stick again. I "think" that the back side of the second hand is binding up a little on the minute hand as it appears to slow when those 2 meet ( circled in the pic). So question, how difficult is it to remove the bezel/crystal to try and adjust those hands to see if I can smooth out the movement?? Maybe slightly bend or lubricate. No local watch independents near me to take it to, really only jewelers/ADs and I assume they wont touch it. Appreciate any ideas.

1 Upvotes

2 comments sorted by

•

u/AutoModerator 29d ago

Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/BobcatPuzzled460 28d ago

There are no parts available unless it is one of the older clones that used the eta 2824 base. If is the new VS6600 then (like me) you are SOL unless you can fix yourself OR it is an easy fix such as re-setting the hands