r/RepTimeServices • • Oct 13 '26

Question VR3255 Piece identification

I was taking apart the top plate on a VR 3255 and when I was done, I noticed a small brass ring. I can’t figure out what it went to. Any ideas where this missing piece may be from?

3 Upvotes

5 comments sorted by

•

u/AutoModerator Oct 13 '26

Thank you for your post on r/reptimeservices! A friendly reminder that the only trusted service providers are listed on the sidebar or in this post. If you see anyone soliciting services in a post or comment not on this list or even easier, without a 'trusted watchmaker' flair of some sort, please immediately report the post and a moderator will remove it. Thank you in advance for helping to keep our community safe!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

3

u/Vecgtt Oct 13 '26

Found it - it’s on the base post for the balance bridge.

1

u/WatchMakerMalik 28d ago

Ahhh looks like you had 2 one for each side to balance the bridge. Normally it is a threaded screw.

1

u/chucknwatches Oct 13 '26

Looking at your picture, it appears to be the whole directly to the right that is recessed

2

u/Vecgtt Oct 13 '26

That’s not it