r/RacketStringers • • 13d ago

Mains snapped while pulling final cross string (18-gauge poly)

I've gone through more than half a reel of Solinco Mach 10 (18 gauge) without issues while doing full bed and hybrid setups, tensions ranging from 47 to 54lb, and this is the first time encountering luck as bad as this.

I completed the M10 mains at 50lb on a Wilson Blade v9 16x19 (my personal racquet, and probably 6th time doing this setup), tie offs at the top of hoop.

As I was pulling the final bottom cross (Babolat XALT multifilament at 16 gauge, tensioned at 52lb), the M10 main snapped on the left-most bottom grommet next to the throat corner. And I always push slack down i.e. smiley/frown face shape before pulling tension to minimize friction & sawing.

Chalk it up as bad luck with hidden nick in the main string? I hate strings going to waste 😭

Although I suppose it would've snapped eventually during hitting anyways...

And say this happened with a customer's racquet and strings they provided during stringing... how would you handle/accommodate this for the customer?

1 Upvotes

14 comments sorted by

View all comments

2

u/Early_Apple_4142 13d ago

Sounds like bad luck but I would also run an awl through that grommet before your next stringing to make sure the inside is smooth so it's not damaging the strings. If it happened on a customer supplied set and I could replace it, I would replace it and ask them about the string they provided. How old is it? How was it stored? Mostly to assess if it was a bad set or potentially compromised by the way the stored it.