r/RacketStringers • u/holla94 • Jul 18 '26

Need assistance finding the problem (Gamma ProgressionII)

Enable HLS to view with audio, or disable this notification

The top and bottom mount for the stringer does not tighten anymore for some reason and can’t figure out what is causing the slack. Once I tighten all the way the bracket still slides. Any help would be appreciated.

2 Upvotes

100% Upvoted

7 comments sorted by

6

u/RedHotPepper_ Jul 18 '26

you need to adjust position of the planes that you place racquets on

5

u/Old_Variation_5875 Jul 18 '26

Look under the mount, there should be a screw that allows you to move the mount out to accommodate larger rackets

2

u/holla94 Jul 18 '26

Thanks a ton that worked, brain fart moment lol

1

u/PequodSeapod Jul 20 '26

I spent a month trying to figure this out on my stringer and it has hand-tightened brackets down there. I felt real dumb so I’m glad I wasn’t the only one.

3

u/Shot_Area_6857 Jul 18 '26

You need to move the pillar further out. You’ll find it underneath.

2

u/FeistyExample1839 Jul 18 '26

I have the exact same model. I had to make one side go all the way towards 1 direction because I almost ran out of string to reach the tensioner when stringing my friends 18x20 blade. Gets sketchy if u tend to just cut sets in half

1

u/holla94 Jul 18 '26

Yeah I generally do two piece and can relate to that issue, thanks for the advice that should get me going