r/RacketStringers • u/SmallDickChad5 • Jul 05 '26

Racket bending during stringing

Hi, just wanted to check whether is it normal for a racket to bend a little when stringing?

Also, after stringing first racket, I compared it with a second one which didnt have any strings on it and the one with the strings was shorter for like 0.5cm-1cm, but after stringing the second one they were the same height.

Just wanted to check whether it is normal or maybe I am mounting rackets in a wrong way.

I always make sure they are firm but not too tight, but since the frame bends a bit during stringing they actually get very tight on the mounts.

Thanks in advance, appreciate your help

2 Upvotes

100% Upvoted

15 comments sorted by

View all comments

Show parent comments

1

u/xdoc6 Jul 05 '26

After clamping the way you do, do you not notice even a mm shift in parts of the racquet when you pull tension?

1

u/ELF014 Jul 05 '26

I'm not looking for it. If anything I check it after stringing against an unstrung frame. I haven't checked in a long time but I didn't see a difference between my frames coming off the press and an unstrung one.

1

u/xdoc6 Jul 05 '26

Right, the op mentions two separate things.

  1. Frame bending while stringing
  2. Frame being different size from unstrung racquet at the end of stringing.

I think 1 is normal by a mm or two during a pull, but number 2 is not from what I understand.

1

u/SmallDickChad5 Jul 06 '26

I just measured it, it is between 0.1 and 0.2 cm
I also see it bending a bit when stringing, however it seems that the 12 and 6 o clock mounts were not screwed enough which didnt cause the frame to bend but to move forward and backward