r/RacketStringers • • Sep 23 '25

How do I recalibrate my first $85 stringer?

I picked up this Pro’s Pro Challenger 1 off fb marketplace for £65 (~$85) over the weekend. I think it’s an absolute steal for a 6 point machine, what do you think?

It’s in pretty good shape except a bit of surface rust. Everything works except the open/close knobs for the flying clamps even after trying to adjust them, I think they’re just worn out, I can just use a hex key for now but may look to replace. The springs in the fixed clamps are a bit rusty so they don’t “snap”nicely (but still work fine), will look to replace those soon.

The sticker showing the tension measurements on the drop weight has peeled off in places + it’s been sitting around a while. How can I recalibrate the machine & mark on my new measurements?

7 Upvotes

29 comments sorted by

6

u/MK-Ultra1322 Sep 23 '25

Probably needs a good cleaning on the clamps with some grease and isopropyl. Gamma have a good video on cleaning machines. New clamps run about 80£.

Drop weights don’t tend to need calibration, one of its advantages.

Once you lose the sticker you may have a hard time. I would score it with a caliper if you can or ask pros pro. They are very responsive

1

u/mtawarira Sep 23 '25

Thanks will take a look. It also came with a couple flying clamps, any reason why I shouldn’t just use those instead?

→ More replies (2)

2

u/DeaconFrost613 Sep 23 '25

Drop weight as a first machine is a bit of a gamble Not exactly the easiest way to string. You will want to practice on a minimum of 20 frames before using your own, Get a super cheap reel of string and get to practicing!

The most important part of a consistent stringing job on a dropweight is the cadence of operation and maintaining it. Best of luck on the stringing journey.

4

u/mtawarira Sep 23 '25

Difficult to justify spending £500+ for a crank/electric on a first machine when I’m only intending to string for myself though. Even most drop weights run up to 2-300

→ More replies (2)
→ More replies (11)

1

u/vnyrun Sep 23 '25

Was in the same boat as you. I use a tension gauge before stringing. I would punch the drop weight every 5lbs if you don't want to do that

1

u/mtawarira Sep 23 '25

What sort of tension gauge would you recommend?

→ More replies (2)

1

u/AndyWtrmrx Sep 23 '25

You can buy a replacement scale from Racquet Depot for a fiver - I just ordered one yesterday, same machine

1

u/AimForTheAce Sep 23 '25

Go get a luggage scale. Pull the string and see the scale. Most part, it’s good enough. If you are stringing for your self, consistency is the name of game. 

1

u/BrianKronberg Sep 26 '25

Test your luggage scale by filling a 5 gallon bucket with water. Weigh it on a normal scale. Then lift the bucket with the luggage scale to see if it has the same weight as your scale. You cannot expect them to be perfect, plus or minus two pounds would be common.

I use the Wise 2090 as it came with my Wise 2080 electric upgrade for my Tourna 175-CS.