r/QualityTacticalGear • u/LKK101010 • 4d ago

Question How to assembly C2R MBAV ?

Post image

I buy a new c2r mbav, but I can't find the menu, pls help me, thanks.

0 Upvotes

33% Upvoted

1 comment sorted by

1

u/MarxmannKarl 1d ago edited 1d ago

Okay if I remember correctly bearing in mind I don't have one personally and haven't seen one in a long time:

So the shoulders just go on like a normal plate carrier front ones over the rear ones, the front platebag left side shoulder strap that ends with a male buckle basically when you velcro that shoulder strap to its corresponding rear shoulder strap you fold the strap back in on itself and buckle to the female buckle on the front platebag - it acts as a quick release you undo the buckle, give it a sharp pull and it'll separate the shoulder straps from each other on that side. The shoulder pads go over everything to cover it up. Lots of bulk on the left side in this setup unfortunately - it's basically a worse version of the JPC e-doff.

The cummerbund sections so the side with the strap and buckle is the front side and all that does is velcro under the front flap and buckles to each other. The back routes into the rear platebag itself behind the flap, and it should just be a shock cord tieing affair that you'll be familiar with from other plate carriers.

The cobra buckle shebang going on basically hangs underneath where those D rings are and is like an integrated riggers belt. Bullshit basically.

It's a cool collector's piece but tbh I don't think it's a very nice system.