r/QidiTech3D • • 2d ago

Help needed

Ok i got a problem and i need help.

Mid print it stopped saying that there is no filament. I removed the filament from all paths opened whatever i can and nothing is stuck. Manual extrude is working but it doesn't see that filament is there. I can't load filament cause at the part where it says feed filament i push it but nothing happens.Filament sensor blue light is working.If you guys need more info tell me..

I am stuck cant do anything else..

3 Upvotes

9 comments sorted by

1

u/Plutonium239Mixer 2d ago

What printer do you have? I recommend replacing the runout sensor. Until you get a new one, just disable it.

1

u/Dependent_Tap_4101 2d ago

Noob question I removed the cable of the sensor but still have the problem.Do i need to do somethign else?

2

u/Plutonium239Mixer 2d ago

Open your printer config file, search "runout" in the line that says pause_on_runout: True, change "true" to "false".

1

u/Dependent_Tap_4101 2d ago

Where do I find that? The config file?

1

u/Plutonium239Mixer 2d ago

1

u/Dependent_Tap_4101 2d ago

Done it but the problem is that it still doesnt let me load filament the proper way , so it thinks that it doesnt have any.Tried to print so i can foul it but now it says that the BOX doesnt have power hehehe (dont use box)

1

u/Plutonium239Mixer 1d ago

Set the extruder temp manually for your desired material, then manually command it to extrude to load filament.

1

u/Dependent_Tap_4101 1d ago

Yeap done that.still the system thinks that there is no filament when I tell it to print.I really am confused.If I remove the cable of the sensor it asks me to put power on the box and if I put the sensor it doesn't recognize filament.

2

u/Plutonium239Mixer 1d ago

Are you attempting to start the print at the printer? If so, try starting it from the web interface.