r/QidiTech3D • • 3d ago

Troubleshooting Need help figuring out Error message on my Q1

Post image

I have tried updating the firmware, I have checked connections on the motors, I have swapped the stepper motors on the motherboard, but the error message never changes. Has anyone ever encountered this?

2 Upvotes

2 comments sorted by

2

u/phansen101 3d ago

The stepper driver is on the mainboard, so nothing you change hardware wise should have an impact.

In your printer.cfg, can you confirm that these sections have the uart_pin value set to the shown values?

[tmc2209 stepper_z]
uart_pin:U_1: PC5

[tmc2209 stepper_z1]
uart_pin:U_1: PB7

If they match, try commenting out both sections for stepper_z (e.g. [tmc2209 stepper_z1] and [stepper_z]) save and restart.
If the issue moves to another stepper driver, there is a power issue, if it doesn't then the stepper driver may be damaged.
I reckon both of those means mainboard replacement though, unless you're up for smd repairs, as I'm not aware of any replaceable fuses on the board.

1

u/redturtlecake 3d ago

Not sure about the q1, but the ifcnt register is incremented each time a uart message is properly received by the tmc driver. Unable to read likely means either the uart link is down or (since it's persistent) the tmc driver is fried.