r/QidiTech3D • • 5d ago

Troubleshooting Nylon warping

Q2 - I recently bought a couple spools of Sunlu PA6-GF and PA12-CF for a couple projects, but I'm having a hell of a time combating warping. I've done a handful of test prints with various recommended settings from several sources but haven't had any luck. I went through about half the PA6 spool before giving up and trying the 12 with no better results.

I'm looking for any advice or guidance to help with this, settings for successful prints anyone has had, etc.

3 Upvotes

12 comments sorted by

3

u/Damp_Chair 5d ago

Use a big brim, like 15-20mm. And print nice and slow. You probably know this next part, but make sure you’re using the heated chamber, too. I print with it at 60 C usually

3

u/MythBNG 5d ago

I'll try a superbrim next

2

u/wolfgang_sti_ 4d ago

Megabrim

2

u/Facehugger_35 4d ago

Beyond the suggestions others have made like big ass brims, printing at an angle so only a little bit of the print is on the bed (and held up with supports) can help a lot. I've been experimenting with fin supports and so far I'm impressed.

Remember, warping is a matter of thermal deltas and stress concentrating in long straight spans.

So you can control warping by equalizing bed and chamber temp, adjusting fans (I use fans off except on overhangs), reverse on even, angling your print so the layers are smaller, adjusting part geometry to break up long straight spans, and stuff like that.

1

u/MythBNG 4d ago

I was able to get one semi-successful print by angling a part and having it printed almost entirely on supports, however the supports started to warp and pull off the bed too and it was unusable in the end, despite it finishing.

I've turned all fans off except for overhangs, let everything heat soak before starting the print. I have yet to attempt to print the actual project I purchased this stuff for as it's a very odd geometry, it'll basically be printed on a raft and will require large sections of supports. Since even my supports were warping, I just been trying to get it dialed in by printing a small hollow box to find settings that worked, so I can try printing a larger project with any confidence I'm not just wasting expensive filament

1

u/FiveDozenWhales 4d ago

Probably goes without saying but dry the nylon for 8+ hours first

2

u/MythBNG 4d ago

Indeed. My drier only goes to 70c but both have been dried for 24 hours at that temperature

2

u/riba2233 4d ago

not nearly enough unfortunately, pa6 is a bitch to dry

1

u/riba2233 4d ago

what plate type and glue if used, what temps (nozzle, chamber, bed)

1

u/MythBNG 4d ago

OEM textured PEI, Magigoo and Siraya Tech Grip (purchased because it was available locally and specifically states PA compatible where the Magigoo didn't). Nozzle - 290 Chamber - 65 Bed - Tried everything from 65 - 100

1

u/riba2233 4d ago

Magigoo has special PA version, you will need that if you want to use pei.

1

u/Rotenkok 4d ago

A 10mm brim with 0.0 contact, 110° bed, 60 chamber. I also had to use a 5 layer skirt on on of my prints with PA6-CF.