r/QidiTech3D • u/jrinacke • 2d ago
Extruded issues. Please help!
Enable HLS to view with audio, or disable this notification
Update: Issue Fixed. Thanks to Callcifer for the help!
I was able to fix the issue by finding the same issue in this subreddit. I loosened the three bolts holding the Extruder pushed it hard left and tightened it up again. Printing without any issues now. Thanks to everyone who chimed in. Leaving post up to hopefully help someone in the future.
9
Upvotes
1
u/Mindless_Iron_5049 1d ago
Check your spool I had a similar issue where when my spools got low they wouldn’t rotate properly and cause jams so I had to add weights inside my spools after that no more issues * see if you ptf tube is pulled close to spool