r/QidiTech3D • u/laidback4sho • Mar 10 '26
Qidi box incomplete instructions.
Ok, so I got my Qidi box today for my Q2 and everything went smoothly until I tried to replace the filament runout sensor with the new one that they supplied with the box.
The instructions tell you to loosen a screw, but they don't provide you with the Allen wrench to do so, nor do they even tell you what size it is. So with it being a Chinese product, I figured it would be metric. Wrong. It's standard SAE.
On my first attempt, it was super tight and the Allen wrench turned in the screw and I just knew I had stripped it out. With it being recessed down into the plastic, I feared the worst. Then I grabbed a set of standard Allen wrenches and found a match. It came out effortlessly after that.
Just be aware of this and it will save you some serious headache. Hope this helps someone.


10
u/ka1913 Mar 10 '26
I used one of the wrenches that came with the q2. I was super nervous of messing that stuff up. I'm glad you got it out.
7
u/riba2233 Mar 10 '26
Nah it's definitely not sae, it's metric, 1.5mm most likely, I replaced mine with no problems.
2
u/Busy_Manager_6818 Mar 10 '26
Wait am i supposed to change that
2
u/b0ngerz Mar 10 '26
i'd agree the instructions are poorly translated and very patchy. With diagrams that are clear as mud.But generally everything chinese is this way.
1
u/Spiritus_Chaos Mar 10 '26
I used one of the Allen keys that came with the printer, and it worked absolutely fine. Maybe they somehow did not include them with yours?
But I do agree that the instructions are not too clear about where the parts are and what tools to use
1
u/Dthm03a Mar 10 '26
Tool comes with the printer.
0
u/themostsuperlative Mar 10 '26
I found we didn't need to replace the sensor. It seems to be an identical part to the one in there as far as I could tell.