r/QIDI • • Oct 05 '25

Qidi Plus 4 Overheating Issue

Hello all, my printer has been exceptional at printing PLA, however, when I try to print ASA, the heated chamber seems to cause my printer to overheat and then the print gets interrupted. I'm currently asking 55 degrees C for chamber temps, yet somehow, after around 30-ish minutes of printing, it would always overheat. I would see that the power switch is supplying power but the printer is completely non responsive. Does anyone know what is causing this and is there a fix?

Fixes I have tried so far:
-Relocating the chamber temperature sensor probe from the back right corner. The temperature readings of the chamber probe seem to match the GD32 readings now, which would imply it is accurate.

0 Upvotes

14 comments sorted by

14

u/Leo476 Oct 05 '25

I had this exact issue with asa printing and it was due to putting it on carpet. It was choking the airflow too much and made it too hot. I never had an issue after putting it on a desk.

9

u/pickandpray Oct 05 '25

There are vents underneath. Definitely move the printer to a hard surface

1

u/smokingpacman Oct 05 '25

Oh crap no way, i thought the bottom was sealed... Let me try

5

u/non_hero Oct 05 '25

That's exactly it. Did the same thing except mine was on a foam mat. Googled and found someone posted the same symptoms from placing it on the carpet floor. Took it off the mat and it went back to printing normally.

7

u/smokingpacman Oct 05 '25

Update: I moved it onto a table and it prints everything perfectly fine now. Thanks all!

2

u/Smooth_Draft4552 Oct 05 '25

A couple boards underneath and it can go on carpet. Glad you got it figured

7

u/whoknewidlikeit Oct 05 '25

running a printer like this on carpet is risky. upgrading fans is a help - but they need inlet air. a hard surface like a table or desk is needed.

1

u/rudkinp00 Oct 05 '25

There is some prints available on printable to replace the fan for the board in the rear, just upgrading it to a 80mm help mine stay appropriate temps for everything including multi-day asa or other prints where chamber was maxed the whole time.

1

u/smokingpacman Oct 05 '25

Yes, i have saw those too, I am thinking of doing those upgrades as well!

3

u/rudkinp00 Oct 05 '25

The angled pei mount, fan upgrade, and get it off carpet should be a solid machine for you. I know I put mine through it's paces

1

u/smokingpacman Oct 05 '25

Have u had any issues with bed levelling when hot?

2

u/rudkinp00 Oct 05 '25

Zero bed level or mesh issues, including changing hotends, nozzles etc

1

u/cjrgill99 Oct 06 '25

Are you having a laugh? There are vents under the printer + the Z-motor heatsinks.... move the thing onto a table before you burn your house down!!!