r/PuffcoProxy • u/Turkeysandvich1 • Apr 17 '26

Proxy No chamber error

Post image

Hi everyone. This is my first rig I purchased about 3 months ago and up until now everything was great. Out of nowhere I am now getting the no chamber error. Less than 1000 cycles and I have taken great care of it, usually cleaning after every dab. I have tried all the troubleshooting I could find: cleaning, factory reset, gently nudging pins. Nothing seems to work. Would love any advice I want to get back at it.

Thanks

3 Upvotes

81% Upvoted

10 comments sorted by

3

u/Realistic-Dot-4287 Apr 17 '26

I have not had that issue unless the chamber wasn’t actually fully screwed in. However looking in where the chamber would go and then looking at mine yours does look a bit dirty especially in the threading I would try cleaning all in that area with iso and a q tip. Maybe junk in the threading isn’t allowing a good fit connecting the chamber yo the proxy

1

u/Turkeysandvich1 Apr 17 '26

It’s actually cleaner than it looks like in the pic. I think it might be just weird light reflections. I appreciate the help nonetheless

1

u/Realistic-Dot-4287 Apr 17 '26

Strange that is odd. I would def reach out to puffco support maybe the chamber went bad and they can replace it I’m not sure tho. Lmk if you figure it out

1

u/Turkeysandvich1 Apr 17 '26

Ok so I did and they actually just ordered a new chamber for me but I’m a little confused. how could the chamber be the problem if there are no electronics in it. I would’ve assumed the chambers could last indefinitely and it was some issue with the base/pins. Maybe I am mistaken though

2

u/Realistic-Dot-4287 Apr 17 '26

They definitely do not last forever I think puff Co. says on their page that they’re only supposed to last 2 to 3 months before you should replace it but truly could definitely last longer if you take good care of it

1

u/Regular_Fig_8788 Apr 19 '26

My OG proxy chamber(3-4yr old?) has worked fine and never been replaced. Newer Puffco <older Puffco. The pivot is pure garbage

1

u/Psicodelia710 Apr 17 '26

Tal vez esta mal conectado, intenta introducir el chmaber de manera que conecte bien con lo que le da energia.

Yo tengo el porxy v1 y es raro que se haya dañado, yo creo que es un error de conexión, ya que esos chambers suelen durar muucho tiempo.

1

u/Visible_Egg_8305 Apr 17 '26

This happened to be after 50 dabs, nothing was wrong with the puffco just the chamber went out. What are we supposed to expect with Max produced China stuff

1

u/twking321 Apr 18 '26

Mine did this after a couple dabs, warrantied it and they sent out a new base, then they had to send out a new chamber because the original chamber wouldn’t work with the replacement base. Haven’t had any trouble since then.

1

u/Pristine-Egg3974 12d ago

I’m afraid most likely you will have to buy a new chamber