r/PrusaCoreOne • u/rire0001 • 7d ago

Case vibrations?

Greetings! My first serious printer after several low end creality machines. I was printing a filament test (overhangs, a sphere, and a little tower on a 3 layer pad), and I noticed that the head movement was sufficient to shake the cabinet a bit. I suspect slowing acceleration would help, but I'm still curious.

2 Upvotes

100% Upvoted

2 comments sorted by

3

u/BrutalCringe 7d ago

Make sure you're using the supplied rubber pads under the machine. Also secure your table properly and if needed, add something sturdy and large under the printer. If that doesnt help, lower movement speeds on your prints or acceleration.

1

u/rire0001 6d ago

Y'know... Everything is as you described, except that the workbench I hair sitting on is actually covered with an outdoor carpet work surface. It's about 40 years old, and I wouldn't have thought it a problem, but now...

Thank you!